Bracelet Size Guide

1. Wrap a soft measuring tape around the wrist where you want the bracelet to sit.
2. Keep the tape close to the skin without pulling tightly. Record the measurement before adding any extra room.
3. If you use string or a strip of paper, mark where the ends meet, then lay it flat against a ruler.
4. Measure a second time to check your reading, and note whether it is in inches or centimeters.

One inch equals 2.54 centimeters. Multiply inches by 2.54 to convert to centimeters, or divide centimeters by 2.54 to convert to inches.

This chart converts measurements; it does not list available bracelet sizes. The builder's maximum wrist reference is 20 cm, about 7.87 inches. If you are close to that limit or above it, contact the studio before ordering.

A closer fit moves less around the wrist; a looser fit allows more movement. Note your preference separately from your actual measurement.

Large beads take up more room against the skin than a fine chain. A mixed-size bracelet can also sit differently from an even strand. Avoid choosing by bead count alone or assuming the length of another bracelet will feel the same.

For Core Collection and Studio Drop, read the Size / Fit information on the product page. Check the bead sizes and photographs alongside the listed measurement.

For a custom stone bracelet, keep your wrist measurement with your design notes. If you are between sizes, giving a gift, or unsure how the beads will sit, email MoonArq support with the measurement and the piece you are considering.